Les Inscriptions à la Bibliothèque sont ouvertes en
ligne via le site: https://biblio.enp.edu.dz
Les Réinscriptions se font à :
• La Bibliothèque Annexe pour les étudiants en
2ème Année CPST
• La Bibliothèque Centrale pour les étudiants en Spécialités
A partir de cette page vous pouvez :
Retourner au premier écran avec les recherches... |
Détail de l'auteur
Auteur Blaabjerg, F.
Documents disponibles écrits par cet auteur
Affiner la rechercheCombined flux observer with signal injection enhancement for wide speed range sensorless direct torque control of IPMSM drives / Andreescu, G. in IEEE transactions on energy conversion, Vol. 23 n°2 (Juin 2008)
[article]
in IEEE transactions on energy conversion > Vol. 23 n°2 (Juin 2008) . - pp. 393 - 402
Titre : Combined flux observer with signal injection enhancement for wide speed range sensorless direct torque control of IPMSM drives Type de document : texte imprimé Auteurs : Andreescu, G., Auteur ; Pitic, C.I., Auteur ; Blaabjerg, F., Auteur Année de publication : 2008 Article en page(s) : pp. 393 - 402 Note générale : Energy conversion Langues : Anglais (eng) Mots-clés : Permanent magnet motors; rotors; synchronous motor drives; torque control Résumé : This paper proposes a motion-sensorless control system using direct torque control with space vector modulation for interior permanent magnet synchronous motor (IPMSM) drives, for wide speed range operation, including standstill. A novel stator flux observer with variable structure uses a combined voltage-current model with PI compensator for low-speed operations. As speed increases, the observer switches gradually to a PI compensated closed-loop voltage model, which is solely used at high speeds. High-frequency rotating-voltage injection with a single D-module bandpass vector filter and a phase-locked loop state observer with a new synchronization procedure are used to estimate the rotor position, which is needed only by the current model in stator flux observer at low speeds. A new rotor speed estimator for the whole speed-loop range, based on the stator flux speed estimation with a new dynamic correction depending on estimated torque, is proposed and tested. Extensive simulation results and significant experimental results provided good performance for the proposed IPMSM sensorless system in more than 1:1000 speed range, under full-load operation, from very low speeds (1 r/min experimental) up to rated speed. En ligne : http://ieeexplore.ieee.org/xpl/articleDetails.jsp?arnumber=4456515&sortType%3Das [...] [article] Combined flux observer with signal injection enhancement for wide speed range sensorless direct torque control of IPMSM drives [texte imprimé] / Andreescu, G., Auteur ; Pitic, C.I., Auteur ; Blaabjerg, F., Auteur . - 2008 . - pp. 393 - 402.
Energy conversion
Langues : Anglais (eng)
in IEEE transactions on energy conversion > Vol. 23 n°2 (Juin 2008) . - pp. 393 - 402
Mots-clés : Permanent magnet motors; rotors; synchronous motor drives; torque control Résumé : This paper proposes a motion-sensorless control system using direct torque control with space vector modulation for interior permanent magnet synchronous motor (IPMSM) drives, for wide speed range operation, including standstill. A novel stator flux observer with variable structure uses a combined voltage-current model with PI compensator for low-speed operations. As speed increases, the observer switches gradually to a PI compensated closed-loop voltage model, which is solely used at high speeds. High-frequency rotating-voltage injection with a single D-module bandpass vector filter and a phase-locked loop state observer with a new synchronization procedure are used to estimate the rotor position, which is needed only by the current model in stator flux observer at low speeds. A new rotor speed estimator for the whole speed-loop range, based on the stator flux speed estimation with a new dynamic correction depending on estimated torque, is proposed and tested. Extensive simulation results and significant experimental results provided good performance for the proposed IPMSM sensorless system in more than 1:1000 speed range, under full-load operation, from very low speeds (1 r/min experimental) up to rated speed. En ligne : http://ieeexplore.ieee.org/xpl/articleDetails.jsp?arnumber=4456515&sortType%3Das [...]
[périodique] Voir les bulletins disponibles Rechercher dans ce périodique
Titre : IEEE transactions on power electronics Type de document : texte imprimé Auteurs : Blaabjerg, F., Editeur scientifique ; Institute of Electrical and Electronics Engineers, Editeur commercial Editeur : New York : Institute of electrical and electronics engineers Année de publication : 1986- Note générale : Périodicité: Bimestrielle
1996-2009Langues : Anglais (eng) Mots-clés : Electronique de puissance Index. décimale : 621.38 Dispositifs électroniques. Tubes à électrons. Photocellules. Accélérateurs de particules. Tubes à rayons X DEWEY : 621 ISSN : 0885-8993 En ligne : http://www.pels.org [périodique] Voir les bulletins disponibles Rechercher dans ce périodique IEEE transactions on power electronics [texte imprimé] / Blaabjerg, F., Editeur scientifique ; Institute of Electrical and Electronics Engineers, Editeur commercial . - New York (345 E., 47th ST.,, 10017-2394) : Institute of electrical and electronics engineers, 1986-.
Périodicité: Bimestrielle
1996-2009
Langues : Anglais (eng)
Mots-clés : Electronique de puissance Index. décimale : 621.38 Dispositifs électroniques. Tubes à électrons. Photocellules. Accélérateurs de particules. Tubes à rayons X DEWEY : 621 ISSN : 0885-8993 En ligne : http://www.pels.org Simple power control for sensorless induction motor drives fed by a matrix converter / Kyo-Beum Lee in IEEE transactions on energy conversion, Vol. 23 n°3 (Septembre 2008)
[article]
in IEEE transactions on energy conversion > Vol. 23 n°3 (Septembre 2008) . - pp. 781 - 788
Titre : Simple power control for sensorless induction motor drives fed by a matrix converter Type de document : texte imprimé Auteurs : Kyo-Beum Lee, Auteur ; Blaabjerg, F., Auteur Année de publication : 2008 Article en page(s) : pp. 781 - 788 Note générale : Energy conversion Langues : Anglais (eng) Mots-clés : Induction motor drives; machine control; matrix convertors; power control; switching convertors Résumé : This paper presents a new and simple method for sensorless control of matrix converter drives using a power flowing to the motor. The proposed control algorithm is based on controlling the instantaneous real and imaginary powers into the induction motor. To improve low-speed sensorless performance, the nonlinearities of a matrix converter drive such as commutation delays, turn-ON and turn-OFF times of switching devices, and on-state switching device voltage drop are modeled using a PQ power transformation and compensated using a reference power control scheme. The proposed sensorless control method is applied for the induction motor drive using a 3 kW matrix converter system. Experimental results are shown to illustrate the feasibility of the proposed strategy. En ligne : http://ieeexplore.ieee.org/xpl/articleDetails.jsp?arnumber=4603065&sortType%3Das [...] [article] Simple power control for sensorless induction motor drives fed by a matrix converter [texte imprimé] / Kyo-Beum Lee, Auteur ; Blaabjerg, F., Auteur . - 2008 . - pp. 781 - 788.
Energy conversion
Langues : Anglais (eng)
in IEEE transactions on energy conversion > Vol. 23 n°3 (Septembre 2008) . - pp. 781 - 788
Mots-clés : Induction motor drives; machine control; matrix convertors; power control; switching convertors Résumé : This paper presents a new and simple method for sensorless control of matrix converter drives using a power flowing to the motor. The proposed control algorithm is based on controlling the instantaneous real and imaginary powers into the induction motor. To improve low-speed sensorless performance, the nonlinearities of a matrix converter drive such as commutation delays, turn-ON and turn-OFF times of switching devices, and on-state switching device voltage drop are modeled using a PQ power transformation and compensated using a reference power control scheme. The proposed sensorless control method is applied for the induction motor drive using a 3 kW matrix converter system. Experimental results are shown to illustrate the feasibility of the proposed strategy. En ligne : http://ieeexplore.ieee.org/xpl/articleDetails.jsp?arnumber=4603065&sortType%3Das [...]