Torque feedforward control technique for permanent-magnet synchronous motors / Bing, Cheng in IEEE transactions on industrial electronics, Vol. 57 N° 3 (Mars 2010)  

Public ISBD [article]  inIEEE transactions on industrial electronics > Vol. 57 N° 3 (Mars 2010) . - pp. 969 - 974 Titre : Torque feedforward control technique for permanent-magnet synchronous motors Type de document : texte imprimé Auteurs : Bing, Cheng, Auteur ; Tesch, Tod R., Auteur Article en page(s) : pp. 969 - 974 Note générale : Génie électrique Langues : Anglais (eng) Mots-clés : Motor parameter variation Optimal operating plane Permanent-magnet synchronous motor Torque feedforward control Index. décimale : 621.38 Dispositifs électroniques. Tubes à électrons. Photocellules. Accélérateurs de particules. Tubes à rayons X Résumé : This paper proposes a torque control method for interior permanent-magnet (IPM) motors operating in a wide speed range requiring high torque/power accuracy and a fast dynamic response. Using the fact that the motor parameters are nonlinear and significantly vary with direct and quadrature current operating points, a new optimal operating plane is generated. This operating plane combines the maximum torque per ampere (MTPA) curve, current limit circle, and maximum torque per volt (MTPV) curve, voltage limitations, and torque calculation under the nonlinear parameter variations. As a result, new feedforward tables are generated, which make full use of measured motor parameters. The new torque and flux regulators built around the feedforward tables provide a fast dynamic response and accurate steady-state torque/power production. The proposed controller was implemented and successfully tested on a 105-kW IPM motor electric drive used in a fuel-cell vehicle program. DEWEY : 621.38 ISSN : 0278-0046 En ligne : http://ieeexplore.ieee.org/xpl/freeabs_all.jsp?arnumber=5382547 [article] Torque feedforward control technique for permanent-magnet synchronous motors [texte imprimé] / Bing, Cheng, Auteur ; Tesch, Tod R., Auteur . - pp. 969 - 974. Génie électrique Langues : Anglais (eng) in IEEE transactions on industrial electronics > Vol. 57 N° 3 (Mars 2010) . - pp. 969 - 974 Mots-clés : Motor parameter variation Optimal operating plane Permanent-magnet synchronous motor Torque feedforward control Index. décimale : 621.38 Dispositifs électroniques. Tubes à électrons. Photocellules. Accélérateurs de particules. Tubes à rayons X Résumé : This paper proposes a torque control method for interior permanent-magnet (IPM) motors operating in a wide speed range requiring high torque/power accuracy and a fast dynamic response. Using the fact that the motor parameters are nonlinear and significantly vary with direct and quadrature current operating points, a new optimal operating plane is generated. This operating plane combines the maximum torque per ampere (MTPA) curve, current limit circle, and maximum torque per volt (MTPV) curve, voltage limitations, and torque calculation under the nonlinear parameter variations. As a result, new feedforward tables are generated, which make full use of measured motor parameters. The new torque and flux regulators built around the feedforward tables provide a fast dynamic response and accurate steady-state torque/power production. The proposed controller was implemented and successfully tested on a 105-kW IPM motor electric drive used in a fuel-cell vehicle program. DEWEY : 621.38 ISSN : 0278-0046 En ligne : http://ieeexplore.ieee.org/xpl/freeabs_all.jsp?arnumber=5382547

Exemplaires

Code-barres	Cote	Support	Localisation	Section	Disponibilité
aucun exemplaire