Single-stage electronic ballast using class-DE low-du/dt current-source-driven rectifier for power-factor correction / Ekkaravarodome, Chainarin in IEEE transactions on industrial electronics, Vol. 57 N° 10 (Octobre 2010)  

Public ISBD [article]  inIEEE transactions on industrial electronics > Vol. 57 N° 10 (Octobre 2010) . - pp. 3405 - 3414 Titre : Single-stage electronic ballast using class-DE low-du/dt current-source-driven rectifier for power-factor correction Type de document : texte imprimé Auteurs : Ekkaravarodome, Chainarin, Auteur ; Nathakaranakule, Adisak, Auteur Année de publication : 2011 Article en page(s) : pp. 3405 - 3414 Note générale : Génie électrique Langues : Anglais (eng) Mots-clés : Class-DE low-du/dt rectifier Class-D parallel resonant inverter Electronic ballast Fluorescent lamps Power-factor correction (PFC) Single stage Index. décimale : 621.38 Dispositifs électroniques. Tubes à électrons. Photocellules. Accélérateurs de particules. Tubes à rayons X Résumé : A single-stage high-power-factor electronic ballast with a Class-DE low-dv/dt rectifier as a power-factor corrector is proposed in this paper. The power-factor corrector is achieved by using a bridge rectifier that acts as the Class-DE low-dv/dt rectifier. The Class-DE low-dv/dt rectifier is driven by a high-frequency current source, which is obtained from the square-wave output voltage of the Class-D parallel resonant inverter through an LC -series circuit. By using this topology, the conduction angle of the bridge rectifier diode current is increased, and a low line-current harmonic is obtained. A prototype ballast is implemented to drive a 36-W fluorescent lamp. The switching frequency is fixed at about 84 kHz. Experimental results verify the theoretical analysis. The designed electronic ballast has a power factor of 0.99, a total harmonic distortion of 1.3%, a lamp current crest factor of 1.42, and 90% efficiency at full power. DEWEY : 621.38 ISSN : 0278-0046 En ligne : http://ieeexplore.ieee.org/xpl/freeabs_all.jsp?arnumber=5406151 [article] Single-stage electronic ballast using class-DE low-du/dt current-source-driven rectifier for power-factor correction [texte imprimé] / Ekkaravarodome, Chainarin, Auteur ; Nathakaranakule, Adisak, Auteur . - 2011 . - pp. 3405 - 3414. Génie électrique Langues : Anglais (eng) in IEEE transactions on industrial electronics > Vol. 57 N° 10 (Octobre 2010) . - pp. 3405 - 3414 Mots-clés : Class-DE low-du/dt rectifier Class-D parallel resonant inverter Electronic ballast Fluorescent lamps Power-factor correction (PFC) Single stage Index. décimale : 621.38 Dispositifs électroniques. Tubes à électrons. Photocellules. Accélérateurs de particules. Tubes à rayons X Résumé : A single-stage high-power-factor electronic ballast with a Class-DE low-dv/dt rectifier as a power-factor corrector is proposed in this paper. The power-factor corrector is achieved by using a bridge rectifier that acts as the Class-DE low-dv/dt rectifier. The Class-DE low-dv/dt rectifier is driven by a high-frequency current source, which is obtained from the square-wave output voltage of the Class-D parallel resonant inverter through an LC -series circuit. By using this topology, the conduction angle of the bridge rectifier diode current is increased, and a low line-current harmonic is obtained. A prototype ballast is implemented to drive a 36-W fluorescent lamp. The switching frequency is fixed at about 84 kHz. Experimental results verify the theoretical analysis. The designed electronic ballast has a power factor of 0.99, a total harmonic distortion of 1.3%, a lamp current crest factor of 1.42, and 90% efficiency at full power. DEWEY : 621.38 ISSN : 0278-0046 En ligne : http://ieeexplore.ieee.org/xpl/freeabs_all.jsp?arnumber=5406151

Exemplaires

Code-barres	Cote	Support	Localisation	Section	Disponibilité
aucun exemplaire