[article] 
inJournal of geotechnical and geoenvironmental engineering > Vol. 135 N° 9 (Septembre 2009) . - pp. 1336–1340

Titre :	Pseudostatic coefficient for use in simplified seismic slope stability evaluation
Type de document :	texte imprimé
Auteurs :	Bray, Jonathan D., Auteur ; Thaleia Travasarou, Auteur
Année de publication :	2009
Article en page(s) :	pp. 1336–1340
Note générale :	Geotechnical and geoenvironmental engineering
Langues :	Anglais (eng)
Mots-clés :	DamEarthquakesDisplacementsReliabilitySeismic effectsSlope stability
Résumé :	Pseudostatic slope stability procedures are commonly used in engineering practice. However, the selection of the seismic coefficient employed in the analysis is often based on precedence without due consideration of the amount of seismic displacement that constitutes satisfactory performance for each particular project and without incorporating the vastly different seismic exposure for sites around the world. In this Note, a rational basis for selecting the seismic coefficient is presented. The proposed procedure requires that the engineer establishes the project-specific allowable level of seismic displacement. The seismic response characteristics of the slope are represented by the fundamental period of the potential sliding mass, and the site-dependent seismic demand is characterized by the 5% damped elastic design spectral acceleration at the degraded period of the potential sliding mass. The level of uncertainty in the estimates of the seismic demand and displacement can be handled through the use of different percentile estimates of these values. With the proposed equations, the engineer can properly incorporate the amount of seismic displacement judged to be allowable and the seismic hazard at the site in the selection of the seismic coefficient.
En ligne :	http://ascelibrary.org/doi/abs/10.1061/%28ASCE%29GT.1943-5606.0000012

[article] Pseudostatic coefficient for use in simplified seismic slope stability evaluation [texte imprimé] / Bray, Jonathan D., Auteur ; Thaleia Travasarou, Auteur . - 2009 . - pp. 1336–1340.
Geotechnical and geoenvironmental engineering
Langues : Anglais (eng)
in Journal of geotechnical and geoenvironmental engineering > Vol. 135 N° 9 (Septembre 2009) . - pp. 1336–1340

Mots-clés :	DamEarthquakesDisplacementsReliabilitySeismic effectsSlope stability
Résumé :	Pseudostatic slope stability procedures are commonly used in engineering practice. However, the selection of the seismic coefficient employed in the analysis is often based on precedence without due consideration of the amount of seismic displacement that constitutes satisfactory performance for each particular project and without incorporating the vastly different seismic exposure for sites around the world. In this Note, a rational basis for selecting the seismic coefficient is presented. The proposed procedure requires that the engineer establishes the project-specific allowable level of seismic displacement. The seismic response characteristics of the slope are represented by the fundamental period of the potential sliding mass, and the site-dependent seismic demand is characterized by the 5% damped elastic design spectral acceleration at the degraded period of the potential sliding mass. The level of uncertainty in the estimates of the seismic demand and displacement can be handled through the use of different percentile estimates of these values. With the proposed equations, the engineer can properly incorporate the amount of seismic displacement judged to be allowable and the seismic hazard at the site in the selection of the seismic coefficient.
En ligne :	http://ascelibrary.org/doi/abs/10.1061/%28ASCE%29GT.1943-5606.0000012