[article] 
inJournal of geotechnical and geoenvironmental engineering > Vol. 134 N°7 (Juillet 2008) . - pp. 1010–1014

Titre :	Use of state-dependent strength in estimating end bearing capacity of piles in sand
Type de document :	texte imprimé
Auteurs :	J. Yang, Auteur ; F. Mu, Auteur
Année de publication :	2008
Article en page(s) :	pp. 1010–1014
Note générale :	Geotechnical and geoenvironmental engineering
Langues :	Anglais (eng)
Mots-clés :	Bearing capacity Piles Pile foundations Sand Shear strength
Résumé :	The pressure and density dependence of the shear strength of sand poses a tricky problem in pile foundation design. In this study, a correlation is suggested to link the effective friction angle of sand with its initial confining pressure and relative density, and a simple approach incorporating this correlation is presented for predicting pile end bearing capacity. Assessment of the approach against pile load tests shows reasonably good agreement between predictions and measurements. It is also shown that the effect of the state-dependent strength is particularly important in cases where long piles are installed in dense sand deposits and the use of critical state friction angle will produce a conservative prediction in such cases.
En ligne :	http://ascelibrary.org/doi/abs/10.1061/%28ASCE%291090-0241%282008%29134%3A7%2810 [...]

[article] Use of state-dependent strength in estimating end bearing capacity of piles in sand [texte imprimé] / J. Yang, Auteur ; F. Mu, Auteur . - 2008 . - pp. 1010–1014.
Geotechnical and geoenvironmental engineering
Langues : Anglais (eng)
in Journal of geotechnical and geoenvironmental engineering > Vol. 134 N°7 (Juillet 2008) . - pp. 1010–1014

Mots-clés :	Bearing capacity Piles Pile foundations Sand Shear strength
Résumé :	The pressure and density dependence of the shear strength of sand poses a tricky problem in pile foundation design. In this study, a correlation is suggested to link the effective friction angle of sand with its initial confining pressure and relative density, and a simple approach incorporating this correlation is presented for predicting pile end bearing capacity. Assessment of the approach against pile load tests shows reasonably good agreement between predictions and measurements. It is also shown that the effect of the state-dependent strength is particularly important in cases where long piles are installed in dense sand deposits and the use of critical state friction angle will produce a conservative prediction in such cases.
En ligne :	http://ascelibrary.org/doi/abs/10.1061/%28ASCE%291090-0241%282008%29134%3A7%2810 [...]