An overview of the hardness differential required for abrasion / Giuseppe Pintaude in Transactions of the ASME . Journal of tribology, Vol. 132 N° 3 (Juillet 2010)  

Public ISBD [article]  inTransactions of the ASME . Journal of tribology > Vol. 132 N° 3 (Juillet 2010) . - 04 p. Titre : An overview of the hardness differential required for abrasion Type de document : texte imprimé Auteurs : Giuseppe Pintaude, Auteur Année de publication : 2011 Article en page(s) : 04 p. Note générale : Tribology Langues : Anglais (eng) Mots-clés : Abrasion Elastoplasticity Hardness Index. décimale : 621.5 Energie pneumatique. Machinerie et outils. Réfrigération Résumé : This paper presents an overview of the hardness differential required for abrasion. Empirically, the abrasive must be at least 1.2 times harder than the worn surface if it is to produce a scratch. This value has been determined theoretically using slip-line field modeling, which assumes rigid-plastic mechanical behavior, an assumption that is inadequate for most abrasive particles. Two approaches using elastic-plastic models and three tribological pairs with similar ratios of abrasive hardness to worn material hardness were tested to gain an understanding of the hardness differential required for abrasion. The analysis showed that the ratios of the property of the abrasive to the property of the worn surface did not change with the model used when the mechanical behavior of the materials was similar. However, when the behavior of the materials was very dissimilar—as is often the case in abrasive processes—the ratios varied greatly depending on the model used, showing that there is a need for models to describe the hardness differential required for abrasion. DEWEY : 621.5 ISSN : 0742-4787 En ligne : http://scitation.aip.org/getabs/servlet/GetabsServlet?prog=normal&id=JOTRE900013 [...] [article] An overview of the hardness differential required for abrasion [texte imprimé] / Giuseppe Pintaude, Auteur . - 2011 . - 04 p. Tribology Langues : Anglais (eng) in Transactions of the ASME . Journal of tribology > Vol. 132 N° 3 (Juillet 2010) . - 04 p. Mots-clés : Abrasion Elastoplasticity Hardness Index. décimale : 621.5 Energie pneumatique. Machinerie et outils. Réfrigération Résumé : This paper presents an overview of the hardness differential required for abrasion. Empirically, the abrasive must be at least 1.2 times harder than the worn surface if it is to produce a scratch. This value has been determined theoretically using slip-line field modeling, which assumes rigid-plastic mechanical behavior, an assumption that is inadequate for most abrasive particles. Two approaches using elastic-plastic models and three tribological pairs with similar ratios of abrasive hardness to worn material hardness were tested to gain an understanding of the hardness differential required for abrasion. The analysis showed that the ratios of the property of the abrasive to the property of the worn surface did not change with the model used when the mechanical behavior of the materials was similar. However, when the behavior of the materials was very dissimilar—as is often the case in abrasive processes—the ratios varied greatly depending on the model used, showing that there is a need for models to describe the hardness differential required for abrasion. DEWEY : 621.5 ISSN : 0742-4787 En ligne : http://scitation.aip.org/getabs/servlet/GetabsServlet?prog=normal&id=JOTRE900013 [...]

Exemplaires

Code-barres	Cote	Support	Localisation	Section	Disponibilité
aucun exemplaire