Documents disponibles écrits par cet auteur

Properties of humid air for calculating power cycles / Sebastian Herrmann in Transactions of the ASME . Journal of engineering for gas turbines and power, Vol. 132 N° 9 (Septembre 2010) 

Public ISBD [article]  in Transactions of the ASME . Journal of engineering for gas turbines and power > Vol. 132 N° 9 (Septembre 2010) . - 08 p. Titre : Properties of humid air for calculating power cycles Type de document : texte imprimé Auteurs : Sebastian Herrmann, Auteur ; Hans-Joachim Kretzschmar, Auteur ; Viola Teske, Auteur Année de publication : 2011 Article en page(s) : 08 p. Note générale : Génie Mécanique Langues : Anglais (eng) Mots-clés : Compressed  air  energy  storage  Thermal  conductivity  Thermodynamic  properties  Viscosity Index. décimale : 620.1 Essais des matériaux. Défauts des matériaux. Protection des matériaux Résumé : Accurate calculation algorithms for the thermodynamic and transport properties of humid air are required for modeling compressed air energy-storage power cycles and designing their individual components. The development of such algorithms was part of the Advanced Adiabatic Compressed Air Energy Storage (AA-CAES) project, which had been supported by the European Commission. To obtain the statements of this paper, all available experimental data and new experimental data generated within the AA-CAES project were used as basis for comparisons between the different models for thermodynamic and transport properties. As a result, one model for calculating thermodynamic and one model for transport properties of humid air in AA-CAES cycle design and operation is recommended. Their application is possible for wide ranges of temperature from 243 K up to 2000 K, total pressure from 0.611 kPa up to 100 MPa, and water content up to 10% mass fraction with some restrictions concerning the calculation of viscosity eta and thermal conductivity lambda (up to 1000 K for both and up to 40 MPa for lambda). These models have been implemented into a property library, which meets the requirements of programs for calculating compressed air energy-storage cycles. The developed property library can be used for the daily work of an engineer who calculates such cycles. The results summarized in this paper have been used for preparing Section 6, “Real Gas” of the ASME Report No. STP-TS-012, “Thermophysical Properties of Gases used in Working Gas Turbine Applications.” DEWEY : 620.1 ISSN : 0742-4795 En ligne : http://scitation.aip.org/getabs/servlet/GetabsServlet?prog=normal&id=JETPEZ00013 [...] [article] Properties of humid air for calculating power cycles [texte imprimé] / Sebastian Herrmann, Auteur ; Hans-Joachim Kretzschmar, Auteur ; Viola Teske, Auteur . - 2011 . - 08 p. Génie Mécanique Langues : Anglais (eng) in Transactions of the ASME . Journal of engineering for gas turbines and power > Vol. 132 N° 9 (Septembre 2010) . - 08 p. Mots-clés : Compressed  air  energy  storage  Thermal  conductivity  Thermodynamic  properties  Viscosity Index. décimale : 620.1 Essais des matériaux. Défauts des matériaux. Protection des matériaux Résumé : Accurate calculation algorithms for the thermodynamic and transport properties of humid air are required for modeling compressed air energy-storage power cycles and designing their individual components. The development of such algorithms was part of the Advanced Adiabatic Compressed Air Energy Storage (AA-CAES) project, which had been supported by the European Commission. To obtain the statements of this paper, all available experimental data and new experimental data generated within the AA-CAES project were used as basis for comparisons between the different models for thermodynamic and transport properties. As a result, one model for calculating thermodynamic and one model for transport properties of humid air in AA-CAES cycle design and operation is recommended. Their application is possible for wide ranges of temperature from 243 K up to 2000 K, total pressure from 0.611 kPa up to 100 MPa, and water content up to 10% mass fraction with some restrictions concerning the calculation of viscosity eta and thermal conductivity lambda (up to 1000 K for both and up to 40 MPa for lambda). These models have been implemented into a property library, which meets the requirements of programs for calculating compressed air energy-storage cycles. The developed property library can be used for the daily work of an engineer who calculates such cycles. The results summarized in this paper have been used for preparing Section 6, “Real Gas” of the ASME Report No. STP-TS-012, “Thermophysical Properties of Gases used in Working Gas Turbine Applications.” DEWEY : 620.1 ISSN : 0742-4795 En ligne : http://scitation.aip.org/getabs/servlet/GetabsServlet?prog=normal&id=JETPEZ00013 [...]