Treatment of pulp and paper mill wastewater using utrafiltration process / Z. Beril Gonder in Industrial & engineering chemistry research, Vol. 51 N° 17 (Mai 2012)  

Public ISBD [article]  inIndustrial & engineering chemistry research > Vol. 51 N° 17 (Mai 2012) . - pp. 6184–6195 Titre : Treatment of pulp and paper mill wastewater using utrafiltration process : Optimization of the fouling and rejections Type de document : texte imprimé Auteurs : Z. Beril Gonder, Auteur ; Semiha Arayici, Auteur ; Hulusi Barlas, Auteur Année de publication : 2012 Article en page(s) : pp. 6184–6195 Note générale : Industrial chemistry Langues : Anglais (eng) Mots-clés : Treatment pulp wastewater Résumé : Treatment of pulp and paper mill wastewater using ultrafiltration (UF) membranes was investigated in this study. A Taguchi experimental design was implemented for design of the experiments to investigate optimum operating conditions that achieve higher removal of pollutants and lower membrane fouling. Four factors at three different levels were considered for the experimental design, namely, pH, temperature, transmembrane pressure, and volume reduction factor (VRF). Under the optimized conditions (pH 10, temperature 25 °C, transmembrane pressure 6 bar, and VRF 3), a 35% flux decline caused by fouling occurred. Higher rejections were observed for total hardness (83%), sulfate (97%), spectral absorption coefficient (SAC254) (95%), and chemical oxygen demand (COD) (89%), but not for conductivity (50%), under these conditions. From the analysis of variance (ANOVA), it was determined that the factor of pH made the greatest contribution to response parameters. Atomic force microscopy (AFM) and scanning electron microscopy (SEM) analyses showed that membrane fouling occurring on the membrane surface and within pores decreased by optimizing the operating conditions. The Taguchi method was successfully applied to find the optimum conditions for the treatment of pulp and paper mill wastewater using the UF process. ISSN : 0888-5885 En ligne : http://pubs.acs.org/doi/abs/10.1021/ie2024504 [article] Treatment of pulp and paper mill wastewater using utrafiltration process : Optimization of the fouling and rejections [texte imprimé] / Z. Beril Gonder, Auteur ; Semiha Arayici, Auteur ; Hulusi Barlas, Auteur . - 2012 . - pp. 6184–6195. Industrial chemistry Langues : Anglais (eng) in Industrial & engineering chemistry research > Vol. 51 N° 17 (Mai 2012) . - pp. 6184–6195 Mots-clés : Treatment pulp wastewater Résumé : Treatment of pulp and paper mill wastewater using ultrafiltration (UF) membranes was investigated in this study. A Taguchi experimental design was implemented for design of the experiments to investigate optimum operating conditions that achieve higher removal of pollutants and lower membrane fouling. Four factors at three different levels were considered for the experimental design, namely, pH, temperature, transmembrane pressure, and volume reduction factor (VRF). Under the optimized conditions (pH 10, temperature 25 °C, transmembrane pressure 6 bar, and VRF 3), a 35% flux decline caused by fouling occurred. Higher rejections were observed for total hardness (83%), sulfate (97%), spectral absorption coefficient (SAC254) (95%), and chemical oxygen demand (COD) (89%), but not for conductivity (50%), under these conditions. From the analysis of variance (ANOVA), it was determined that the factor of pH made the greatest contribution to response parameters. Atomic force microscopy (AFM) and scanning electron microscopy (SEM) analyses showed that membrane fouling occurring on the membrane surface and within pores decreased by optimizing the operating conditions. The Taguchi method was successfully applied to find the optimum conditions for the treatment of pulp and paper mill wastewater using the UF process. ISSN : 0888-5885 En ligne : http://pubs.acs.org/doi/abs/10.1021/ie2024504

Exemplaires

Code-barres	Cote	Support	Localisation	Section	Disponibilité
aucun exemplaire