Documents disponibles écrits par cet auteur

Pre-stall instability distribution over a transonic compressor rotor / A. J. Gannon in Transactions of the ASME . Journal of fluids engineering, Vol. 131 N° 5 (Mai 2009) 

Public ISBD [article]  in Transactions of the ASME . Journal of fluids engineering > Vol. 131 N° 5 (Mai 2009) . - 11 p. Titre : Pre-stall instability distribution over a transonic compressor rotor Type de document : texte imprimé Auteurs : A. J. Gannon, Auteur ; G. V. Hobson, Auteur Année de publication : 2009 Article en page(s) : 11 p. Note générale : fluids engineering Langues : Anglais (eng) Mots-clés : transonic  compressor  rotor;  stall Résumé : An investigation of the behavior of a transonic compressor rotor when operating close to stall is presented. The specific areas of interest are the behavior and location of low-frequency instabilities close to stall. In running close to stall, compressors can begin to exhibit nonperiodic flow between the blade passages even when appearing to be operating in a stable steady-state condition. The data from the current rotor clearly show that low-frequency instabilities were present during steady-state operation when stall was approached. These frequencies are not geometrically fixed to the rotor and typically appear at 0.3–0.8 of the rotor speed. The presence of these low-frequency instabilities is known and detection is reasonably commonplace; however, attempts to quantify the location and strength of these instabilities as stall is approached have proved difficult. In the current test fast response pressure sensors were positioned in the case-wall; upstream, downstream, and over the rotor blade tips. Simultaneous data from the sensors were taken at successive steady-state settings with each being closer to stall. A time domain analysis of the data investigates the magnitude of the instabilities and their transient effect on the relative inlet flow angle. The data are also presented in the frequency domain to show the development and distribution of the instabilities over the rotor as stall was approached. Initially the instabilities appeared within the rotor row and extended downstream but at operation closer to stall they began to protrude upstream as well. The greatest amplitude of the instabilities was within the blade row in the complex flow region that contains phenomena such as the tip-vortex/normal-shock interaction and the shock/boundary-layer interaction. In addition as stall is approached the growth of the instabilities is nonlinear and not confined to one frequency. En ligne : http://fluidsengineering.asmedigitalcollection.asme.org/issue.aspx?journalid=122 [...] [article] Pre-stall instability distribution over a transonic compressor rotor [texte imprimé] / A. J. Gannon, Auteur ; G. V. Hobson, Auteur . - 2009 . - 11 p. fluids engineering Langues : Anglais (eng) in Transactions of the ASME . Journal of fluids engineering > Vol. 131 N° 5 (Mai 2009) . - 11 p. Mots-clés : transonic  compressor  rotor;  stall Résumé : An investigation of the behavior of a transonic compressor rotor when operating close to stall is presented. The specific areas of interest are the behavior and location of low-frequency instabilities close to stall. In running close to stall, compressors can begin to exhibit nonperiodic flow between the blade passages even when appearing to be operating in a stable steady-state condition. The data from the current rotor clearly show that low-frequency instabilities were present during steady-state operation when stall was approached. These frequencies are not geometrically fixed to the rotor and typically appear at 0.3–0.8 of the rotor speed. The presence of these low-frequency instabilities is known and detection is reasonably commonplace; however, attempts to quantify the location and strength of these instabilities as stall is approached have proved difficult. In the current test fast response pressure sensors were positioned in the case-wall; upstream, downstream, and over the rotor blade tips. Simultaneous data from the sensors were taken at successive steady-state settings with each being closer to stall. A time domain analysis of the data investigates the magnitude of the instabilities and their transient effect on the relative inlet flow angle. The data are also presented in the frequency domain to show the development and distribution of the instabilities over the rotor as stall was approached. Initially the instabilities appeared within the rotor row and extended downstream but at operation closer to stall they began to protrude upstream as well. The greatest amplitude of the instabilities was within the blade row in the complex flow region that contains phenomena such as the tip-vortex/normal-shock interaction and the shock/boundary-layer interaction. In addition as stall is approached the growth of the instabilities is nonlinear and not confined to one frequency. En ligne : http://fluidsengineering.asmedigitalcollection.asme.org/issue.aspx?journalid=122 [...]