Catalogue en ligne Bibliothèque de l'Ecole Nationale Polytechnique

Les Inscriptions et les Réinscriptions à la Bibliothèque sont Ouvertes du 24/09/2024 au 30/11/2024

Nouvelle recherche Modifier la recherche Historique

Nos Abonnements

Ressources Électroniques

Design and manufacture of a windmill for pumping water / Hichem Idris Aouidad (2024)

Design and manufacture of a windmill for pumping water [document électronique] / Hichem Idris Aouidad, Auteur ; Mohamed Amine Ammari, Auteur ; Abdelhamid Bouhelal, Directeur de thèse ; Benbraika, Mohamed, Directeur de thèse . - [S.l.] : [s.n.], 2024 . - 1 fichier PDF (4.6 Mo).

Mode d'accès : accès au texte intégral par intranet.
Mémoire de Projet de Fin d’Études : Génie Mécanique : Alger, École Nationale Polytechnique : 2024
Bibliogr. p. 91-94. - Appendices
Langues : Anglais (eng)
Mots-clés : Wind energy
Windmill
Reverse engineering
Aerodynamic analysis
CFD
Index. décimale : PM01224
Résumé :
This project addresses the critical need for decentralized water production by developing a wind-powered water pumping system. Using reverse engineering and rigorous optimization, parts were designed with CAD software, a scale model was created via 3D printing, and CFD simulations were employed to analyze aerodynamic performance. The wind pump showed significantly higher pumping capacity than the one installed at the POVAL company. The scaled-down wind turbine model was tested in a wind tunnel to validate the simulation results.

Les Inscriptions et les Réinscriptions à la Bibliothèque sont Ouvertes du 24/09/2024 au 30/11/2024

Nos Abonnements

Ressources Électroniques

Bibliothèque de l'Ecole Nationale Polytechnique

Accueil

Sélection de la langue

Se connecter

Adresse

Météo

Mots-clés :	Wind energy Windmill Reverse engineering Aerodynamic analysis CFD
Index. décimale :	PM01224
Résumé :	This project addresses the critical need for decentralized water production by developing a wind-powered water pumping system. Using reverse engineering and rigorous optimization, parts were designed with CAD software, a scale model was created via 3D printing, and CFD simulations were employed to analyze aerodynamic performance. The wind pump showed significantly higher pumping capacity than the one installed at the POVAL company. The scaled-down wind turbine model was tested in a wind tunnel to validate the simulation results.